ioLogik E2242 Active Ethernet I/O with 4 analog inputs and 12

ioLogik E2242 Active Ethernet I/O with 4 analog inputs and 12 configurable DIOs

Highlights

• 4 fixed differential analog input channels
• 12 configurable digital input/output channels
• DI counter saved automatically when power shuts off
• Instant event messaging by TCP/UDP/email/SNMP-Trap
• PC-based configuration utility and web console
• Easy-to-use Click&Go Logic for local output control
• Windows/WinCE VB/VC.NET and Linux C APIs
• I/O control over Modbus/TCP and SNMP protocol
• NIST traceable calibration

Includes

• 1 x ioLogik E2200 Series unit
• 1 x support CD/DVD

Specs:

Ethernet
1 x 10/100 Mbps, RJ45

Protection
1.5 KV magnetic isolation

Protocols
Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP (MIB for I/O and Network), HTTP, CGI, SNTP

Interface
RS-485-2w Data+, Data-, GND

Serial Line Protection
15 KV ESD for all signals

Channels
4 analog inputs with differential input

Resolution
16 bits

I/O Mode
Voltage / Current

Input Range
±150 mV, 0 to 150 mV, ±500 V, 0 to 500 mV, ±5 V, 0 to 5 V, ±10 V, 0 to 10 V, 0 to 20 mA, 4 to 20 mA

Accuracy
±0.1% FSR @ 25°C
±0.3% FSR @ -10 and 60°C

Sampling Rate (all channels)
100 samples/sec

Input Impedance
200K ohms (min.)

Built-in Resistor for Current Input
102 ohms

Channels
12

I/O Mode
DI or Event Counter (up to 900 Hz)
DO or Pulse Output (up to 100 Hz)

Channels
Up to 12, source/sink selectable

Sensor Type
NPN, PNP, and Dry contact

Dry Contact
Logic 0 short to GND; Logic 1 Open

Wet Contact
(For Source Type)
Logic 0 0 to 3 VDC; Logic 1 10 to 30 VDC

Channels
Up to 12, sink type, 36 VDC, 200 mA

I/O Mode
DO or Pulse Output (up to 100 Hz)

Isolation
2K Vrms or 3K VDC (Magnetic)

Overview:

Better I/O Matrix for Monitoring—Moxa's ioLogik E2242 is tailormade for use with remote monitoring and alarm systems.

This Active Ethernet I/O product provides 4 analog inputs and 12 configu-rable DIOs for a 1:3 ratio of analog IOs to digital IOs perfectly adapted to water tank monitoring and environmental monitoring applications, in which 1 analog input is used to trigger 3 digital outputs as High-High, High, and Low alarms. Moxa's ioLogik E2242 lets you set up our monitoring system without the need for a local PC or RTU.