ioLogik E2240 Active Ethernet I/O with 8 analog inputs and 2

ioLogik E2240 Active Ethernet I/O with 8 analog inputs and 2 analog outputs

Highlights

• 8-channel analog inputs for v oltage, current signal
• 2-channel analog outputs for voltage, current actuator control
• Instant event messaging by TCP/UDP/email/SNMP-trap
• Easy-to-use Click&Go Logic for local output control
• PC-based configuration utility and web console
• Windows/WinCE VB/VC.NET and Linux C APIs
• I/O control over Modbus/TCP and SNMP protocol
• NIST-traceable calibration

Includes

• 1 x ioLogik E2200 Series unit
• 1 x support CD/DVD

Specs:

Ethernet
1 x 10/100 Mbps, RJ45

Protection
1.5 KV magnetic isolation

Protocols
Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP (MIB for I/O and Network), HTTP, CGI, SNTP

Interface
RS-485-2w Data+, Data-, GND

Serial Line Protection
15 KV ESD for all signals

Channels
8 analog inputs with differential input

Resolution
16 bits

I/O Mode
Voltage / Current

Input Range
±150 mV, ±500 mV, ±5 V, ±10 V, 0 to 20 mA, 4 to 20 mA

Data Format
16-bit integer (2's complement)

Accuracy
±0.1% FSR @ 25°C
±0.3% FSR @ -10 and 60°C

Sampling Rate (all chann
els)
10 samples/sec for voltage
6 samples/sec for current

Input Impedance
900K ohms (min.)

Built-in Resistor for Current Input
106 ohms

CMR @ 50/60 Hz
95 dB min.

Zero Drift
±9 μV/°C

Span Drift
±25 ppm/°C

Isolation
3K VDC or 2K Vrms

Channels
2

Resolution
12 bits

Output Range
0 to 10 V, 4 to 20 mA

Drive Voltage
15 VDC for current output

Accuracy
±0.1% FSR @ 25°C
±0.3% FSR @ -10 and 60°C

Zero Drift
±9 μV/°C

Span Drift
±25 ppm/°C

Load Resistor
Less than 250 ohms

Overview:

Combination of analog input and outputThe ioLogik E2240 comes with a combination of analog inputs andanalog outputs in one module, and supports a wide range of sensors andactuators, including pH, conductivity, pressure, flow, and valves.