ioLogik E2210 Active Ethernet I/O with 12 digital inputs and 8

ioLogik E2210 Active Ethernet I/O with 12 digital inputs and 8 digital outputs

Highlights

• Instant event messaging by TCP/UDP/email/SNMP-trap
• Easy-to-use Click&Go Logic for local output control
• 12-point 24 VDC digital input with counter
• 8-point 24 VDC digital output with pulse output
• PC-based configuration utility and web console
• I/O control over Modbus/TCP and SNMP protocol
• Windows/WinCE VB/VC.NET and Linux C APIs
• Peer-to-Peer I/O without controller

Includes

• 1 x ioLogik E2200 Series unit
• 1 x support CD/DVD

Specs:

Ethernet
1 x 10/100 Mbps, RJ45

Protection
1.5 KV magnetic isolation

Protocols
Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP (MIB for I/O and Network), HTTP, CGI, SNTP

Interface
RS-485-2w Data+, Data-, GND

Serial Line Protection
15 KV ESD for all signals

Channels
12, source type

Sensor Type
NPN, Dry contact

Dry Contact
Logic 0 short to GND
Logic 1 open

Wet Contact
Logic 0 0 to 3 VDC
Logic 1 10 to 30 VDC (DI COM to DI)

Channels
8, sink type, 36 VDC, 200 mA

I/O Mode
DO or Pulse Output (up to 100 Hz)

Isolation
3K VDC or 2K Vrms

Overview:

Simple Applications without Programming The ioLogik E2210 can convert a trigger event result directly into a digital alarm output. This can be set up using the ioAdmin UI to define an IF-THEN Logic rule, eliminating the need to write programs for PCs or controllers.

Software Event Counter Input and Pulse Output Each digital input can be independently configured for DI or Event Counter mode, and output can be independently configured for DO or Pulse Output mode.